1-833-300-2114

Increase your hose assembly service life by avoiding routing mistakes

Here are six quick tips on the correct routing of hose assemblies. They are simple, common sense principles that can prolong your hose's service life and prevent hose failure.

Avoid twisting assembliesAvoid twisting assemblies

Bending a hydraulic hose assembly in more than one plane causes twisting of its wire reinforcement. A  twist of five degrees can reduce the service life of a high-pressure hydraulic hose by as much as 70%. A seven degree twist can result in a 90% reduction in service life.

 

Hose bend radius too tightDo not bend hoses tightly

Allow ample bend radius to avoid hose collapse of the line and restriction of flow. Never bend the hose tighter than the minimum bend radius specified by the hose’s manufacturer. Assure that the bend does not start right at the fitting.

 

 

Hose bend radius too tight

Using adapters to solve routing problemsUse elbows or other adapters

Use elbows or other adapters to ensure the minimum bend radii are within limits specified by the hose’s manufacturer, to reduce needed hose length and to enable hose assemblies to be routed neater – away from harm’s way.

 

 

 

Using hose clamps to improve routingUse hose clamps

Using clamps is an important aspect of proper routing. Clamps secure the hose in its proper position and help to keep it from being pulled, hit, crushed or rubbing against surrounding moving parts.

 


 

Hose assemblies get shorter under pressurePrevent assemblies from becoming fully extended

As hose assemblies get pressurized, their diameter increases and they become slightly shorter. If a hose is permitted to assume a fully extended state, it may be too short when pressurized. The result is the hose being pulled out of the fittings. With repeated cycles, this will decrease the hose’s service life and can lead to a failure. Design at least a slight bend/slack to any hose route to prevent this from happening.

Protect assemblies from damage

Hydraulic hose manufacturers estimate that 80% of hose failures are attributable to external physical damage through pulling, kinking, crushing or abrasion of the hose. Abrasion caused by hoses rubbing against each other or surrounding surfaces is the most common type of damage.

To prevent external damage, ensure all clamps are kept secure, pay careful attention to routing whenever a replacement hose is installed and if necessary, use hoses with abrasion resistant cover and/or apply polyethylene spiral wrap to protect hydraulic hoses from abrasion.

Posted by Marek Bobik

Related Articles
Hose Reinforcement Matters

Hose Reinforcement Matters

Wire Braid Reinforcement vs. Wire Spiral Reinforcement What’s the difference? Why should you care?...
Read More
Keep your hydraulic system healthy - choose the right diagnostic tool

Keep your hydraulic system healthy - choose the...

It is surprising to see how many people still prefer analog meters over digital ones. It is true...
Read More
Busted power steering hose? Save money - salvage your hose ends!

Busted power steering hose? Save money - salvage...

We have all been there. Your power steering hose, transmission hose or AC hose starts leaking and...
Read More
Hydraulic Fitting Selection – Differences Among Attachment Styles

Hydraulic Fitting Selection – Differences Among...

We get a few requests per month for a standard fitting. In the world of fittings, there isn’t any...
Read More